#Carsoft 7.4 r170 series
I need a senior member to clarify If I can put in the procedures on the forumīut anyway on scanning the vehicle, seems like I got more than a bargained for, a series of Errors after Errors, but it looks like I do have an Electrical problem, maybe this was caused by faulty electrical work that was done to the car previously or perhaps its a central unit like the SAM which is faulty, I really do not know now and I am so devastated.
#Carsoft 7.4 r170 software
Maybe because I am into I.T, but I have to admit it took me 2 days to sort it out and hours of searching on forums and not throwing in the towel.īecause of the forum rules, I cannot discuss software issues etc, but you are free to contact me directly. Now I can charge £30 for anyone wanting a diagnosis. The harness on the coolant sensor did broke off 2 years ago and I did soldered it back.
On performing the individual test on the Instrument Cluster, it showed up the coolant sensor need cleaning. It did showed up one test failure on Instrument Cluster. I had an ABS sensor failure a couple of years ago and I fitted a new sensor. I did a complete digital tests on my 97 W202, I was amazed there are digital tests, I am expecting analogue tests. The ABS error is still there saying it couldn't find the module. The PSE errors is still there I presumed I have taken it off the road for a month, there may be no vacuum may be correct, I hope this will go away after a drive.ĭ2B(Audio)error is gone after I reset the error and retested. I tried to fix the error it highlighted about the ESP by turning extreme left and right and reset the error and did the test again, the error gone. I know this known error as the battery had been disconnected and reconnected, BAS/ASR light on can be rectify by steering extreme left and rightĬan't look up these codes, what does it means and what I do with the Can Bus error? Verify the power supply at terminal 87 :While IGNITION = ON : 11-14 V Verify the power supply at terminal 30 :While IGNITION = OFF : 11-14 V Status: Module is not build in, or does not respondĪBS is present but said it couldn't find it.Ĭ1140 Steering angle sensor, Open-circuit/short-circuit initialisation P0221 Generic Throttle/Pedal Position Switch B Circuit Range/PerformanceĬan't look up these codes, what does it means? This is ME single test(petrol engine control unit) I am literate but I need experience reading CarSoft 7.4 test resultsġ.